Alpine IVA D106 Owner's Manual - Page 55
Phase Switching, Graphic Equalizer Adjustments, Select L/R or L+R by touching
UPC - 793276200594
View all Alpine IVA D106 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Phase Switching Setting item : PHASE Switch the phase (0° or 180°) by touching [ ] or [ ] of the desired speaker. Graphic Equalizer Adjustments The graphic equalizer allows you to modify the sound using 31 bands each for the front (left and right), rear (left and right) and center speakers. An additional 10 bands are available for the subwoofer. This allows you to customize the sound to suit your taste. Setting item : G-EQ 1 Select L/R or L+R by touching [ ] or [ ] of G-EQ. L/R: L+R: Different adjustment values can be set for the left and right channels. Sets the same adjustment values for the left and right channels. When parametric EQ is adjusted, this setting will be turned off. 2 Touch [ ] of G-EQ. The G-EQ list screen appears. 3 Touch [ ] of the desired speaker (channel). The G-EQ adjustment screen appears. 4 Adjust the G-EQ to your preference. Adjusting the Level Touch [ ] or [ ] of the desired frequency to adjust the level. • When the speaker is set to the "OFF" mode, the graphic equalizer for that speaker cannot be set. Refer to "Setting the Speakers" (page 51), "Speaker Setup" (page 54). • Check the playable frequency ranges of the connected speakers before making the equalizer adjustments. If the speaker's playable frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz or 20 Hz band has no effect. Additionally, you may overload and damage the speakers. • When graphic EQ is adjusted, the adjustment for parametric EQ becomes ineffective. Parametric Equalizer Adjustments The frequency bands of the graphic equalizer are fixed. This makes it very difficult to correct for undesired peaks and dips at specific frequencies. The parametric equalizer's center frequency can be tuned to these specific frequencies. Then, the bandwidth (Q) and level are fine-tuned, independently, to make the necessary corrections. The parametric equalizer function is an advanced tool for serious audiophiles. Setting item : P-EQ 1 Select L/R or L+R by touching [ ] or [ ] of P-EQ. L/R: L+R: Different adjustment values can be set for the left and right channels. Sets the same adjustment values for the left and right channels. When graphic EQ is adjusted, this setting will be turned off. 2 Touch [ ] of P-EQ. The P-EQ list screen appears. 3 Touch [ ] of the desired speaker (channel). The P-EQ adjustment screen appears. 4 Adjust the P-EQ to your preference. Selecting the Band Touch [ ] or [ ] of BAND. Select the desired band. Adjusting the Frequency Touch [ ] or [ ] of FREQ., then adjust the frequency of the selected band. Adjusting the Level Touch [ ] or [ ] of LEVEL, then adjust the level of the selected band. Setting the Bandwidth Touch [ ] or [ ] of Q. Select the bandwidth. • When the speaker is set to the "OFF" mode, the parametric equalizer for that speaker cannot be set. Refer to "Setting the Speakers" (page 51), "Speaker Setup" (page 54). • It is not possible to adjust the frequencies of adjacent bands within 7 steps. • Check the playable frequency ranges of the connected speakers before making the equalizer adjustments. If the speaker's playable frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz or 20 Hz band has no effect. Additionally, you may overload and damage the speakers. • When the parametric EQ is adjusted, the adjustment for graphic EQ becomes ineffective. 53-EN