Alpine IVA D106 Owner's Manual - Page 22

Caution • Not all functions will operate for every DVD. See the individual DVD's instructions for details on the features supported. • Fingerprints on a disc may adversely affect playback. If a problem occurs, remove the disc and check for fingerprints on the playback side. Clean the disc if necessary. • If you switch the power or Ignition Key OFF or change sources during playback, playback will continue where you left off when you resume playback. • If you try to perform an invalid operation (based on the type of disc being played), the following mark is displayed on the monitor screen: If a menu screen appears On DVDs and Video CDs with playback control (PBC), menu screens may appear automatically. If this happens, perform the operation described below to start playback. • To play back a DVD-Audio disc, set "VCAP" in "Setting the DVD- Audio Playback Mode" (page 34). Direct Menu Operations 1 Touch the DVD menu directly. • Some operations cannot be performed depending on the disc. Menu Operations • Play Position Memory Function Even if you turn power off or switch the Ignition Key to OFF during playback or change the source, playback will continue from the point where playback stopped when the power is turned ON again. 1 Touch [SOURCE] on the main source screen. The SOURCE selection screen is displayed. 2 Touch [DVD PLAYER]. The display shows the DVD mode screen. Insert a disc with the label side facing up. The unit starts to play the disc. When an optional Alpine DVD player is connected: Insert a disc into the DVD/Video CD/CD player, the player starts playing. • The operation screen changes to the visual screen in the DVD or Video CD mode for 5 seconds after an operation has been performed. Touch the display panel to display the operation screen again. • The display mode can be changed by touching [WIDE]. For operation, see "Switching Display Modes" on page 29. To eject the disc Press . • The reverse side of a double-sided DVD will not be played automatically. Remove the disc, turn it over, and reinsert it. • If the disc does not eject, press and hold for at least 3 seconds. • Do not insert discs containing maps for the navigation system. Doing so could result in damage. • Refer also to "DVD Setup" (pages 30 to 35). • Be sure the remote input lead is connected to the remote output lead of this unit when a DVD changer or DVD player is connected. If not correctly connected, touch operation cannot be performed. • To return to the previous screen during Video CD playback, touch [RETURN] after touching [P1/2] of the function guide. However, the function may vary depending on the disc. • If the disc is left in the unit after pressing , the disc is automatically pulled back into the unit and stopped. In this case, start playback by touching [ / ] or eject again and remove the disc within 15 seconds. • While "INDEX READING" is displayed by DivX®, the fastforwarding/fast-reversing and repeat functions, etc. cannot be used. 1 Touch [KEY]. The menu operation mode will be displayed. Touch [RETURN] to return to the previous display. (Operation may not be possible, depending on the disc.) 2 Select a desired menu item by touching or [ ]. 3 Touch [ENTER] to confirm the selected item. 20-EN