Alpine IVA D106 Owner's Manual - Page 31

Rear Selection Function While listening to the radio or other audio source, at the same time, pictures in a disc inserted in the IVA-D106 can be enjoyed in the rear monitor. However, only pictures are output, not sound. 1 Touch [SOURCE] on the main source screen. The SOURCE selection screen is displayed. 2 Touch [REAR]. Rear Select display appears. • This function cannot be used when "Setting the Picture/Sound Output" (page 39) is set to OFF in the SYSTEM SETUP. • If [MAIN] on the Rear Select screen is touched, the screen changes to the main source screen. 3 Touch the desired source such as visual (auxiliary input, built-in DVD, etc.) to select. • Touch [OFF] to cancel the rear entertainment function. • When the "Setting the AUX Mode" (page 39) is set to OFF, the auxiliary source is not displayed. Switching Display Modes After carrying out the steps 1 to 3 of "To display the DVD mode screen" explained on page 30, perform the operation described below. While your vehicle is parked, touch [WIDE] on the visual source screen or press BAND on the unit. Each touch changes the display modes as follows: MODE 1 MODE 2 MODE 3 MODE 1 (WIDE) (CINEMA) (NORMAL) (WIDE) In Mode 1 (Wide), the monitor displays a normal picture wider to fit in a wide-screen monitor by evenly stretching out the picture horizontally. In Mode 2 (Cinema), the monitor displays a normal picture by stretching out the picture horizontally and vertically. This mode is good for displaying a cinema type picture at the 16 : 9 ratio. In Mode 3 (Normal), the monitor displays a normal picture at the center of the screen with a vertical black band at each side. • To play back a DVD-Audio disc, set "VCAP" in "Setting the DVD- Audio Playback Mode" (page 34). Switching the Visual Source Only (Simultaneous Function) You can watch the video portion of another source while listening to the current source. • After carrying out the steps 1 to 3 of "To display the DVD mode screen" explained on page 30, perform the operation described below. 1 Touch [VISUAL] on the audio source screen. The VISUAL selection screen appears. 2 Touch a desired visual source. The visual source is switched to the selected one. Canceling the Simultaneous Function 1 Press VISUAL. 2 Touch [NORMAL]. The simultaneous function is canceled. • To apply the setting, set to VISUAL in "Setting the VISUAL Button" (page 39). • If a DVD player is connected, you can receive the DVD picture. DVD changer (DHA-S680) is connected: Press and hold V.OUT on the remote control supplied with the DVD player or DVD changer for more than 2 seconds. The picture of the DVD will be output. The DVA-5210 is connected: Press V.OUT on the remote control (included with the DVA-5210) to output DVD picture. • The simultaneous function cannot be used when the Audio source is in the navigation mode. When NAV. is set in "Setting the VISUAL Button" (page 39), only the navigation screen can be recalled. • When the "Setting the AUX Mode" (page 39) is set to OFF, the auxiliary source is not displayed. 29-EN