Brother International DreamMaker„ XE VE2200 Users Manual - English - Page 10

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS NAMES OF MACHINE PARTS AND THEIR FUNCTIONS The names of the various parts of the machine and their functions are described below. Before using the machine, carefully read these descriptions to learn the names of the machine parts. Machine ■ Front View ■ Right-side/Rear View a Top cover Open the top cover to thread the machine and wind the bobbin. b Pre-tension disk Pass the thread around the pre-tension disk when winding the bobbin thread. (page B-31) c Thread guide for bobbin winding Pass the thread through this thread guide when winding the bobbin thread. (page B-31) d Spool pin Place a spool of thread on the spool pin. (page B-38) e Spool cap Use the spool cap to hold the spool of thread in place. (page B-38) f Supplemental spool pin Use this spool pin to wind the bobbin thread. (page B-31) g Bobbin winder Use the bobbin winder when winding the bobbin. (page B-31) h LCD (liquid crystal display) Settings for the selected pattern and error messages appear in the LCD. (page B-20) i Speaker j Operation buttons (5 buttons) Use these buttons to operate the machine. (page B-10) k Embroidery unit Attach the embroidery unit to embroider (page B-47). l Thread cutter Pass the threads through the thread cutter to cut them. (page B-40) m Thread guide plate Pass the thread around the thread guide plate when threading upper thread. (page B-38) a Connector for the presser foot Connect the embroidery foot "W+" with LED pointer. (The embroidery foot "W+" with LED pointer is optional on certain models.) (page B-42) b Handle Carry the machine by its handle when transporting the machine. c Presser foot lever Raise and lower the presser foot lever to raise and lower the presser foot. (page B-42) d Air vent The air vent allows the air surrounding the motor to circulate. Do not cover the air vent while the machine is being used. e Main power switch Use the main power switch to turn the machine ON and OFF. (page B-17) f Power cord receptacle Insert the power cord into the machine receptacle. (page B-17) g Sensor pen holder connector (For models equipped with the sensor function) Connect the included sensor pen holder. (page B-53) h Sensor pen jack (For models equipped with the sensor function) Connect the sensor pen. (page B-53) i USB port for computer In order to import/export patterns between a computer and the machine, plug the USB cable into the USB port. (page B-49, E-47) j USB port for mouse / media In order to send patterns from/to USB media, plug the USB media directly into the USB port. (page B-49, E-46) Connect the USB mouse to operate with mouse. (page B-50) k Handwheel Rotate the handwheel toward you (counterclockwise) to raise and lower the needle. The wheel should be turned toward the front of the machine. B-8