Brother International DreamMaker„ XE VE2200 Users Manual - English - Page 45
Checking the Needle Drop Point, With the Embroidery Foot W, with LED Pointer For Embroidery, foot
View all Brother International DreamMaker„ XE VE2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
CHANGING THE EMBROIDERY FOOT a Position the embroidery foot "W+" with LED pointer or "W" on the presser foot bar d Press to unlock all keys and by aligning the notch of the presser foot to the large screw. Side view buttons. → All keys and operation buttons are unlocked, and the previous screen is displayed. B 1 Getting Ready b Hold the embroidery foot your right hand, and then in place with use the included screwdriver to securely tighten the embroidery foot screw. ■ Checking the Needle Drop Point With the Embroidery Foot "W+" with LED Pointer (For Embroidery foot "W+" with LED pointer user only) Before beginning to embroider when using the embroidery foot "W+" with LED pointer, carefully read the procedures described in the "Embroidery" and "Embroidery Edit" chapters. a Press in the embroidery screen. → The LED pointer indicates the needle drop point. → For users of embroidery foot "W", skip step c and go to step d. CAUTION • Use the included screwdriver to firmly tighten the screw of the embroidery foot. If the screw is loose, the needle may strike the embroidery foot and possibly cause injury. c Plug the connector of the embroidery foot "W+" with LED pointer into the jack on the back of your machine. Memo • When the LED pointer is turned on, the presser foot height is automatically adjusted according to the fabric thickness. • If is pressed again, the fabric thickness is remeasured and the presser foot is set to the optimum height. * The LED pointer turns off automatically by lowering the presser foot or returning to the previous page. Note • With bulky fabrics, the position may not be accurate due to the various depths of the fabrics. • With fabric that has a very uneven surface such as quilting, the fabric thickness may not be correctly measured. In this case, the pointer indication should be used only as a reference. Basic operations B-43