Casio FX-CG10 Software User Guide - Page 575
Starting a Sampling Operation, E-Con2
View all Casio FX-CG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 575 highlights
ε-30 Starting a Sampling Operation 8. Starting a Sampling Operation This section describes how to use a setup configured using the E-Con2 mode to start an EA-200 sampling operation. k Before getting started... Be sure to perform the following steps before starting sampling with the EA-200. 1. Connect the calculator to the EA-200. 2. Turn on EA-200 power. 3. In accordance with the setup you plan to use, connect the proper sensor to the appropriate EA-200 channel. 4. Prepare the item whose data is to be sampled. k Starting a Sampling Operation A sampling operation can be started when any one of the following conditions exist. • After configuring a new setup with Setup Wizard (page ε-2) • After configuring a new setup with Advanced Setup (page ε-8) • While the E-Con2 main menu (page ε-1) is on the display • While the setup memory list is on the display The following procedures explain the first three conditions described above. See "To recall a setup and use it for sampling" on page ε-25 for information about starting sampling from the setup memory list. • To start sampling 1. Start the sampling operation by performing one of the function key operations described below. - If the final Setup Wizard screen (page ε-4) is on the display, press b(Start Setup). - If the Advanced Setup menu (page ε-8) is on the display, press 1(START). - If the E-Con2 main menu (page ε-1) is on the display, press 4(START). • After you perform any one of the above operations, a sampling start confirmation screen like the one shown nearby will appear on the display. 20100801