Casio FX-CG10 Software User Guide - Page 599
microphone. Leaving FFT Graph turned on cause memory capacity to be exceeded. - instructions
View all Casio FX-CG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 599 highlights
ε-54 Calling E-Con2 Functions from an eActivity • To graph sampled data from an Econ Graph strip 1. On the eActivity workspace screen, use the f and c keys to move the highlighting to the Econ Graph strip. 2. Press w. • If this Econ Graph strip already has sampled data registered to it because of a previous execution, a graph of the existing data will appear on the display. In this case, jump to step 5 of this procedure. • If this is the first time you are executing this Econ Graph strip, the Advanced Setup screen will appear on the display. If this happens, proceed with step 3 of this procedure. 3. Perform steps 4 and 5 under "To configure an EA-200 setup using Advanced Setup" (page ε-8) to configure the setup for sampling. 4. Press 1(START). • As instructed by the message that appears on the display, press the w key to perform sampling. • After sampling is complete, the data will be graphed in accordance with the setup settings. 5. To return to the eActivity workspace screen from the graph screen, press !a('). • Econ Strip Memory Capacity Precautions • The memory capacity of each Econ strip is 25 KB. An error will occur if you perform an operation that causes this capacity to be exceeded. Particular care is required when handling a large number of samples, which can cause memory capacity to be exceeded. • Always make sure that FFT Graph is turned off whenever performing sampling with the microphone. Leaving FFT Graph turned on cause memory capacity to be exceeded. • If an error occurs, press !a(') to return to the eActivity workspace screen and perform the procedure again. • For information about checking the memory usage of each strip, see "To display the strip memory usage screen" on page 10-21. 20100801