Dell PowerEdge C6100 Hardware Owner's Manual - Page 77
System Memory, Installing the Infiniband Mezzanine Card, Supported DIMM Configuration
View all Dell PowerEdge C6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Installing the Infiniband Mezzanine Card CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Place the mezzanine card on the system-board assembly. See Figure 3-14 and Figure 5-11. 2 Replace the three screws that secure the mezzanine card to the back of the system board tray. See Figure 3-14. 3 Replace the screw that secures the mezzanine card side bracket to the system board tray. See Figure 3-14. 4 Replace the system-board assembly. See "Installing a System-Board Assembly" on page 62. 5 Reconnect all the cables to the mezzanine card. 6 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals. System Memory Each system board has twelve unbuffered or registered DDR3-DIMM slots for the installation of up to twelve DDR3-1066/1333 memory chips to support processor 0 and processor 1. See "System Board Connectors" on page 129 for the location of the memory modules. Supported DIMM Configuration For the sequence of the twelve DIMM sockets, see Figure 3-15. When you insert the DIMM(s), always start with DIMM0_CHA. See Table 3-2 for possible memory configurations. Installing System Components 77