Dell PowerEdge C6100 Hardware Owner's Manual - Page 97
Fan Controller Board, Removing the Fan Controller Board
View all Dell PowerEdge C6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
7 Replace the power supply. See "Installing a Power Supply" on page 60. 8 Close the system. See "Closing the System" on page 92. 9 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals. Fan Controller Board Removing the Fan Controller Board CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 Open the system. See "Opening the System" on page 91. 3 Remove the power distribution boards. See "Removing a Power Distribution Board" on page 94. 4 Disconnect all the cables from the fan controller board. See Figure 5-12. Note the routing of the cable underneath the tabs on the chassis as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped. 5 Remove the screw securing the fan controller board to the chassis. See Figure 3-25. 6 Slide and lift the fan controller board out of the chassis. See Figure 3-25. Installing System Components 97