Garmin GPSMAP 298C Owner's Manual - Page 9
Using Simulator Mode, To place the GPSMAP 292/298 in Simulator Mode - gpsmap 298 c
UPC - 753759052072
View all Garmin GPSMAP 298C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Using Simulator Mode Simulator Mode turns the GPS receiver off for use indoors or practice. You can perform any of the functions discussed in the following pages in Simulator Mode. Keep in mind that the GPSMAP 292/298 does not track satellites in Simulator Mode, and this mode should never be used for actual navigation. All the waypoint and route planning completed in Simulator Mode is retained in memory for future use. WARNING: Do not attempt to navigate using Simulator Mode. When the unit is set to Simulator Mode, the GPS receiver is turned off. Any satellite signal strength bars shown are only simulations and do not represent the strength of actual satellite signals. BASIC OPERATION > USING SIMULATOR MODE To place the GPSMAP 292/298 in Simulator Mode: 1. Press and hold ADJ/MENU to show the Main Menu. Press up or down on the ROCKER until the GPS tab is highlighted, and then press ADJ/MENU once. 2. Use the ROCKER to highlight Start Simulator, and press ENTER. 3. Press QUIT to confirm the Running Simulator message that appears at the bottom of the screen. If the status bar is turned on, "Simulating" appears at the top of each of the main pages. 4. To turn off the Simulator Mode, press ADJ/MENU, and select Stop Simulator. GPSMAP 292/298 Owner's Manual 3