Sony DCR-SC100 Operating Instructions - Page 79

Consejos para utilizar el, paquete de pilas, Tips for using the battery

Page 79 highlights

Tips for using the battery pack Consejos para utilizar el paquete de pilas When to replace the battery pack While you are using your camcorder, the remaining battery indicator on the LCD screen decreases gradually as battery power is used up. The remaining time in minutes also appears. Cuándo sustituir el paquete de pilas Mientras utiliza la videocámara, el indicador de capacidad restante de las pilas de la pantalla LCD disminuye gradualmente en tanto se agota la energía de las pilas. También aparece el tiempo restante en minutos. When the remaining battery indicator reaches the lowest point, the i indicator appears and starts flashing on the LCD screen. When the i indicator changes from slow flashing to rapid flashing while you are recording, set the POWER switch to OFF on the camcorder and replace the battery pack. Leave the tape in the camcorder to obtain a smooth transition between scenes after the battery pack has been replaced. Cuando el indicador de capacidad restante de las pilas alcanza el punto más bajo, el indicador i aparece y comienza a parpadear en la pantalla LCD. Si el parpadeo del indicador i cambia de lento a rápido durante la grabación, ajuste el interruptor POWER de la videocámara en OFF y sustituya el paquete de pilas. Deje la cinta en la videocámara para obtener una transición uniforme entre las escenas una vez sustituido el paquete de pilas. Notes on the rechargeable battery pack Caution Never leave the battery pack in temperatures above 140°F (60°C), such as in a car parked in the sun or under direct sunlight. The battery pack heats up During charging or recording, the battery pack heats up. This is caused by energy that has been generated and a chemical change that has occurred inside the battery pack. This is not cause for concern, and is normal. Notas sobre el paquete de pilas recargable Precaución No exponga nunca el paquete de pilas a temperaturas superiores a 140°F (60°C), como en un automóvil aparcado al sol o bajo la luz solar directa. Calentamiento del paquete de pilas Durante la carga o la grabación, el paquete de pilas se calienta. Esto se debe a la energía que se genera y al cambio químico que se produce en el interior de dicho paquete. Esto no es motivo de preocupación, ya que es normal. 78

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116

78
Consejos para utilizar el
paquete de pilas
Cuándo sustituir el paquete de
pilas
Mientras utiliza la videocámara, el indicador de
capacidad restante de las pilas de la pantalla
LCD disminuye gradualmente en tanto se agota
la energía de las pilas.
También aparece el tiempo restante en minutos.
Cuando el indicador de capacidad restante de las
pilas alcanza el punto más bajo, el indicador
i
aparece y comienza a parpadear en la pantalla
LCD.
Si el parpadeo del indicador
i
cambia de lento a
rápido durante la grabación, ajuste el interruptor
POWER de la videocámara en OFF y sustituya el
paquete de pilas. Deje la cinta en la videocámara
para obtener una transición uniforme entre las
escenas una vez sustituido el paquete de pilas.
Notas sobre el paquete de pilas
recargable
Precaución
No exponga nunca el paquete de pilas a
temperaturas superiores a 140°F (60°C), como en
un automóvil aparcado al sol o bajo la luz solar
directa.
Calentamiento del paquete de pilas
Durante la carga o la grabación, el paquete de
pilas se calienta. Esto se debe a la energía que se
genera y al cambio químico que se produce en el
interior de dicho paquete. Esto no es motivo de
preocupación, ya que es normal.
Tips for using the battery
pack
When to replace the battery
pack
While you are using your camcorder, the
remaining battery indicator on the LCD screen
decreases gradually as battery power is used up.
The remaining time in minutes also appears.
When the remaining battery indicator reaches the
lowest point, the
i
indicator appears and starts
flashing on the LCD screen.
When the
i
indicator changes from slow
flashing to rapid flashing while you are
recording, set the POWER switch to OFF on the
camcorder and replace the battery pack.
Leave
the tape in the camcorder to obtain a smooth
transition between scenes after the battery pack
has been replaced.
Notes on the rechargeable
battery pack
Caution
Never leave the battery pack in temperatures
above 140°F (60°C), such as in a car parked in the
sun or under direct sunlight.
The battery pack heats up
During charging or recording, the battery pack
heats up.
This is caused by energy that has been
generated and a chemical change that has
occurred inside the battery pack.
This is not
cause for concern, and is normal.