Sony STR-DN840 Operating Instructions (Large File - 14.22 MB) - Page 34
Before you perform Auto, Calibration, To set up the Auto, Confirm active subwoofer, setup - test
View all Sony STR-DN840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
• Measure the distance of each speaker from your seating position.1) • Measure the speaker size.1) • Measure the frequency characteristics (EQ).1) • Measure the frequency characteristics (Phase).1)2) 1) The measurement result is not utilized when "Analog Direct" is selected. 2) The measurement result is not utilized when Dolby TrueHD or DTS-HD signals with a sampling frequency of more than 48 kHz are being received. The DCAC is designed to achieve proper sound balance for your room. However, you can adjust the speaker levels manually according to your preference. For details, see "Test Tone" (page 92). Before you perform Auto Calibration Before you perform Auto Calibration, check the following items. • Set up and connect the speakers (page 20, 22). • Connect only the supplied optimizer microphone to the AUTO CAL MIC jack. Do not connect any other microphones to this jack. • Set the "SB Assign" to "Bi-Amp" in the Speaker Settings menu if you use biamplifier connection (page 90). • Set the "SB Assign" to "Speaker B" in the Speaker Settings menu if you use speakers front B connection (page 90). • Make sure the speaker output is not set to "SPK OFF" (page 35). • Make sure that you are not using PARTY STREAMING function (page 68). • Disconnect the headphones. • Remove any obstacles in the path between the optimizer microphone and the speakers to avoid measurement errors. • Get accurate measurement by making sure the environment is quiet. Notes • The speakers emit very loud sound during the calibration and the volume cannot be adjusted. Provide consideration to your neighborhood and to the children in presence. • If the muting function has been activated before you perform Auto Calibration, the muting function will shut off automatically. • The correct measurements may not be able to take or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used. To set up the Auto Calibration Optimizer microphone 1 Connect the supplied optimizer microphone to the AUTO CAL MIC jack. 2 Set up the optimizer microphone. Place the optimizer microphone at your seating position and set it at the same height as your ears. Confirm active subwoofer setup • When a subwoofer is connected, turn on the subwoofer and turn up the volume prior to activating the subwoofer. Turn the LEVEL to just before the mid-point. • If you connect a subwoofer with a crossover frequency function, set the value to maximum. 34US