AIWA NSX-999 Operating Instructions - Page 26
The Dsp Digital Signal Processor
View all AIWA NSX-999 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
1 9PRGM MANUA 2 CURSOR CONTROL A 4 b T (K) wh CURSOR CONTROL 3 A 4 b v @ b @ r DELAY - D-VOL1 1IN L* R - FB ON/OFF J 5 26 DSP DISCO Ml LIVE M2 MOVIE M3 b HALL M4 PRGM MANUA B THE DSP (.DIGITAL SIGNAL PROCESSOR) , To cancel the selected DSP mode+ u Press the OFF button of the DSP so that S-OFF is displayed. When the music source is monaural A simulated stereo effect can be obtained by selecting the LIVE and MOVIE modes. The other modes. keep the source monaural. PRESETTING A DSP SURROUND SOUND MANUALLY 1 Press the PRGMIMANUAL button of the DSP so that one of the DSP Ml to M4 indicators in the display is surrounded by red. 2 Press one of the CURSOR CONTROL buttons to display DELAY. While DELAY is displayed, go to the next step. 3 Press the CURSOR CONTROL buttons to adjust the reverb time and delay time. 4/>: To select elements for DSP sound + @ A/T: To adjust the level or switch the position DELAY (delav time) Increasing the number in the display increases the delay time and surround effect. 12,18,32,41,49,98,130 mSec and the off position can be selected. D-VOL (delay volume) Increasing the number in the display increases the reverb effect level and surround effect. -15, -12, -9, -6, -3, O, +3 and the off position can be selected. FB ON/OFF (feedback) When FB ON is displayed, the sound is echoed. IN L*R (input mode) When L+R is displayed, the surround effect increases, especially in the center. When L-R is displayed, it increases on the outside. 4 Press the GEQ/DSP MEMORY button. While MEMO is displayed, go to the next step, If MEMO goes out, press it again. 5 Press one of the DSP Ml -M4 buttons to store the reverb level and delay time. To select a manual-preset DSP 1 Press the PRGM/MANUAL button of the DSP so that one of the DSP Ml to M4 indicators in the display is surrounded by red, 2 Press one of the DSP Ml -M4 buttons. The equalization curve stored in GEQ Ml -M4 is automatically selected with corresponding to DSP Ml -M4. To select with the remote control Press the DSP MANU button until the desired mode is displayed. To check the DSP settings Prees the + or F CURSOR CONTROL buttons. (If you press the A or T button, the settings are changed.) The CURSOR CONTROL buttons They can be also used to adjust the GE(2 function. Be sure to press the PRGM/MANUAL button of the DSP before using them.