Cisco NME-16ES-1G User Guide - Page 156

16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Configuration Examples for the 16- and 36-Port Ethernet Switch Module Changing the Switch Priority Example The following example shows how to set the switch priority to 100 for bridge group 10: Switch(config)# bridge 10 priority 100 Changing the Interface Priority Example The following example shows how to change the priority of an interface to 20 in bridge group 10: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# bridge-group 10 priority 20 Assigning a Path Cost Example The following example shows how to change the path cost on an interface to 10 in bridge group 10: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# bridge-group 10 path-cost 20 Adjusting BPDU Intervals Example You can adjust BPDU intervals as described in these sections: • Adjusting the Interval between Hello BPDUs Example, page 156 • Changing the Forward-Delay Interval Example, page 156 • Changing the Maximum-Idle Interval Example, page 156 Adjusting the Interval between Hello BPDUs Example The following example shows how to change the hello interval to 5 seconds in bridge group 10: Switch(config)# bridge 10 hello-time 5 Changing the Forward-Delay Interval Example The following example shows how to change the forward-delay interval to 10 seconds in bridge group 10: Switch(config)# bridge 10 forward-time 10 Changing the Maximum-Idle Interval Example The following example shows how to change the maximum-idle interval to 30 seconds in bridge group 10: Switch(config)# bridge 10 max-age 30 Disabling the Spanning Tree on an Interface Example The following example shows how to disable spanning tree on an interface in bridge group 10: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# bridge group 10 spanning-disabled 156 Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ