Cisco NME-16ES-1G User Guide - Page 225

16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series show mls masks show mls masks To display the details of the Access Control Parameters (ACPs) used for quality of service (QoS) and security access control lists (ACLs), use the show mls masks command in privileged EXEC mode. show mls masks [qos | security] Syntax Description qos security (Optional) Displays ACPs used for QoS ACLs. (Optional) Displays ACPs used for security ACLs. Note ACPs are called masks in the command-line interface (CLI) commands and output. Command Modes Privileged EXEC Command History Release 12.1(6)EA2 12.2(15)ZJ Modification This command was introduced. This command was implemented on the following platforms: Cisco 2600 series, Cisco 3600 series, and Cisco 3700 series routers. Usage Guidelines Use the show mls mask command without keywords to display all ACPs configured on the switch. Use this command with the qos keyword to display the ACPs used for QoS ACLs. Use this command with the security keyword to display the ACPs used for security ACLs. Note You can configure up to four ACPs (QoS and security) on a switch. Examples The following is sample output from the show mls masks command: Switch# show mls masks Mask1 Type : qos Fields : ip-sa(0.0.0.255), ip-da(host), dest-port Policymap: pmap1 Interfaces: Fa0/9, Gi0/1 Policymap: pmap2 Interfaces: Fa0/1, Fa0/5, Fa0/13 In this example, Mask 1 is a QoS ACP consisting an IP source address (with wildcard bits 0.0.0.255), an IP destination address, and Layer 4 destination port fields. This ACP is used by the QoS policy maps pmap1 and pmap2. Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ 225