Cisco WS-C2960S-24PD-L Software Guide - Page 158
Setting MVR Parameters
View all Cisco WS-C2960S-24PD-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Configuring MVR Chapter 6 Configuring the System Setting MVR Parameters You do not need to set MVR parameters if you choose to use the default settings. If you do want to change the default parameters, you must do so before enabling MVR. Beginning in privileged EXEC mode, follow these steps to configure MVR parameters: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 Command Purpose configure terminal Enter global configuration mode. mvr querytime value (Optional) Define the maximum time to wait for IGMP report memberships on a receiver port before removing the port from multicast group membership. The value is in units of tenths of a second. The default is 5 tenths or one-half second. mvr vlan vlan-id (Optional) Specify the VLAN in which multicast data will be received; all source ports must belong to this VLAN. The default is VLAN 1. interface interface Enter interface configuration mode, and enter the type and number of the port to configure, for example, fastethernet 0/1. mvr threshold value (Optional) Define the maximum of multicast data packets received on a receiver port before it is administratively shut down. The default is 20. end Exit configuration mode. show mvr show mvr interface Verify the configuration. copy running-config startup-config Save your configuration changes to nonvolatile RAM (NVRAM). 6-30 Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide 78-6511-08