Cisco WS-C2960S-24PD-L Software Guide - Page 188
Configuring RADIUS Login Authentication
View all Cisco WS-C2960S-24PD-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
Controlling Switch Access with RADIUS Chapter 6 Configuring the System To remove the specified RADIUS server, use the no radius-server host hostname | ip-address global configuration command. This example shows how to configure one RADIUS server to be used for authentication and another to be used for accounting: Switch(config)# radius-server host 172.29.36.49 auth-port 1612 key rad1 Switch(config)# radius-server host 172.20.36.50 acct-port 1618 key rad2 This example shows how to configure host1 as the RADIUS server and to use the default ports for both authentication and accounting: Switch(config)# radius-server host host1 Note You also need to configure some settings on the RADIUS server. These settings include the IP address of the switch and the key string to be shared by both the server and the switch. For more information, refer to the RADIUS server documentation. Configuring RADIUS Login Authentication To configure AAA authentication, you define a named list of authentication methods and then apply that list to various interfaces. The method list defines the types of authentication to be performed and the sequence in which they are performed; it must be applied to a specific interface before any of the defined authentication methods are performed. The only exception is the default method list (which is named default). The default method list is automatically applied to all interfaces except those that have a named method list explicitly defined. A method list describes the sequence and authentication methods to be queried to authenticate a user. You can designate one or more security protocols to be used for authentication, thus ensuring a backup system for authentication in case the initial method fails. The software uses the first method listed to authenticate users; if that method fails to respond, the software selects the next authentication method in the method list. This process continues until there is successful communication with a listed authentication method or until all defined methods are exhausted. If authentication fails at any point in this cycle-meaning that the security server or local username database responds by denying the user access-the authentication process stops, and no other authentication methods are attempted. 6-60 Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide 78-6511-08