Cisco WS-C2960S-24PD-L Software Guide - Page 70

Menus and Toolbar Chapter 2 Getting Started with CMS Device Popup Menus Specific devices in the Topology view display a specific popup menu: • Cluster (Table 2-20) • Command switch (Table 2-21) • Member or standby command switch (Table 2-22) • Candidate switch with an IP address (Table 2-23) • Candidate switch without an IP address (Table 2-24) • Neighboring devices (Table 2-25) Note The Device Manager option in these popup menus is available in read-only mode on Catalyst 2900 XL and Catalyst 3500 XL switches running Release 12.0(5)WC2 and later. It is also available on Catalyst 2950 switches running Release 12.1(6)EA2 and later and on Catalyst 3550 switch running Release 12.1(8)EA1 or later. It is not available on the Catalyst 1900 and Catalyst 2820 switches. To display a device popup menu, click an icon, and right-click. Table 2-20 Device Popup Menu of a Cluster Icon Popup Menu Option Expand cluster Properties Task View a cluster-specific topology view. Display information about the device and port on either end of the link and the state of the link. Table 2-21 Device Popup Menu of a Command-Switch Icon Popup Menu Option Task Collapse cluster Host Name1 View the neighborhood outside a specific cluster. Change the host name of a switch. Bandwidth Graphs Display graphs that plot the total bandwidth in use by the switch. Properties Display information about the device and port on either end of the link and the state of the link. 1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the "Access Modes in CMS" section on page 2-33. Table 2-22 Device Popup Menu of a Member or Standby Command-Switch Icon Popup Menu Option Remove from Cluster1 Host Name1 Device Manager2 Task Remove a member from the cluster. Change the host name of a switch. Launch Device Manager for a switch. 2-26 Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide 78-6511-08