Cisco WS-C2960S-24PD-L Software Guide - Page 317
PERF5_HALT_MSG Message, PM Messages
View all Cisco WS-C2960S-24PD-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 317 highlights
Appendix A System Messages Error Message and Recovery Procedures PERF5_HALT_MSG Message This section contains the PERF5 halt (manufacturing test) error message. Error Message PERF5_HALT_MSG-1-PERF5HALTERR: Restarting conversation [dec] [chars]\n [chars] Tx [dec] frames, Rx [dec] frames\n [chars] Tx [dec] frames, Rx [dec] frames\n Explanation An halt error causes the Perf5 test to either restart or halt. Recommended Action Based on the error message, locate the problem, correct it, and rerun the test. PM Messages This section contains the Port Manager error messages. Error Message PM-2-NOMEM: Not enough memory available for [chars] Explanation The Port Manager subsystem could not obtain the memory it needed. Recommended Action Copy the error message exactly as it appears on the console or in the system log. Enter the show tech-support command to gather data that might provide information to determine the nature of the error. If you cannot determine the nature of the error from the error message text or from the show tech-support output, contact your Cisco technical support representative, and provide the representative with the gathered information. Error Message PM-3-NON_SWITCHABLE_PORT: Non-switchable port:[chars]. Explanation A switchport configuration command is only valid on ports that support hardware packet switching. Recommended Action Do not attempt to use switchport commands on standard routed ports. Check the name of the interface you are configuring against the actual hardware. Error Message PM-3-PORT_NOT_SHUTDOWN: [chars]. Explanation A switchport configuration command is only valid on ports that are shut down. Recommended Action Do not attempt to use switchport commands until the port is shut down. 78-6511-08 Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide A-25