Cisco WS-C2960S-24PD-L Software Guide - Page 52
Port Modes and LEDs, Mode LED, Description
View all Cisco WS-C2960S-24PD-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Front Panel View Chapter 2 Getting Started with CMS Port Modes and LEDs The port modes (Table 2-6) determine the type of information displayed through the port LEDs. When you change port modes, the meanings of the port LED colors (Table 2-7, Table 2-8, and Table 2-9) also change. Note The bandwidth utilization mode (UTL LED) does not appear on the front-panel images. Select Reports > Bandwidth Graphs to display the total bandwidth in use by the switch. Refer to the switch hardware installation guide for information about using the UTL LED. To select or change a mode, click the Mode button until the desired mode LED is green. Table 2-6 Port Modes Mode LED Description STAT Ethernet link status of the 10/100, 100BASE-FX, or 1000BASE-X switch ports, or the Ethernet link status on the remote customer premises equipment (CPE) device. Default mode on all Catalyst 2900 XL and Catalyst 3500 XL switches except the Catalyst 2900 LRE XL switches. LRE (Catalyst 2900 LRE XL only) Long-Reach Ethernet (LRE) link status of the LRE ports on the Catalyst 2900 LRE XL switches. Default mode on these switches only. Note When the LRE mode is active, the 10/100 switch ports on the Catalyst 2900 LRE XL continue to show Ethernet link status. FDUP or DUPLX Duplex setting on the ports. Default settings are: • 10/100 ports: Auto • 100BASE-FX ports: Auto • Gigabit ports: Auto • LRE ports: Half-duplex Note In this mode on the Catalyst 2900 LRE XL switches, the LRE port LEDs show the duplex mode used on the CPE Ethernet link between the remote CPE and an Ethernet device. SPEED or SPD Speed setting on the ports. Default setting is auto on the 10/100 ports. Note In this mode on the Catalyst 2900 LRE XL switches, the LRE port LEDs show the link speed between the remote CPE and an Ethernet device. LINE PWR Inline power setting on the Catalyst 3524-PWR XL 10/100 ports. Default setting is auto. (Catalyst 3524-PWR XL only) Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide 2-8 78-6511-08