Cisco WS-C2960S-24PD-L Software Guide - Page 301
CPU_NET Message, ENVIRONMENT Messages
View all Cisco WS-C2960S-24PD-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 301 highlights
Appendix A System Messages Error Message and Recovery Procedures Error Message CMP-5-MGMT_VLAN_CHNG: The management vlan has been changed to [dec] Explanation The management VLAN has been changed. Recommended Action No action is required. CPU_NET Message This section contains the CPU network interface error message. Error Message CPU_NET-0-QUEUE_STUCK: The interface between the CPU and the switch has\nbecome stuck. The switch must now reset to clear this condition\n.Retrieval queue [dec].\n Explanation The CPU can no longer communicate with the network. Recommended Action Reload the system. ENVIRONMENT Messages This section contains the environment error messages. Error Message ENVIRONMENT-2-FAN_FAULT: System Fault: FAN FAULT is detected. Explanation This message means that an internal fan fault is detected. This message is available only on the Catalyst 3524-PWR XL switch. Recommended Action Either check the switch itself, or use the show env privileged EXEC command to check if a fan on the switch has failed. The Catalyst 3524-PWR XL switch can operate normally with one failed fan. Replace the switch at your convenience. Error Message ENVIRONMENT-2-OVER_TEMP: System Fault:OVER TEMPERATURE condition is detected. Explanation This message means that an overtemperature condition is detected. This message is available only on the Catalyst 3524-PWR XL switch. Recommended Action Use the show env command to check if an overtemperature condition exists. If it does: • Place the switch in an environment that is within 32 to 113°F (0 to 45°C). • Make sure fan intake and exhaust areas are clear. If a multiple-fan failure is causing the switch to overheat, replace the switch. 78-6511-08 Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide A-9