Cisco WS-C2960S-24PD-L Software Guide - Page 314
MAT Messages
View all Cisco WS-C2960S-24PD-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 314 highlights
Error Message and Recovery Procedures Appendix A System Messages Error Message LRE_LINK-3-PROFILE_FAILURE: Interface [chars], profile [chars] failure Explanation When the switch reloads or when the LRE link is lost, the LRE port first attempts to briefly establish link with the CPE in a common, reduced rate mode. This is so that the switch can exchange configuration information with the CPE to achieve the link rate of the profile configured for the port. When the reduced rate is achieved, link is dropped briefly, and the LRE and CPE ports attempt to establish the profile link rate. If, after a time (typically 30 seconds), no LRE link is established, this message appears, and the port LED is amber. The port continues to attempt to establish link, starting from the reduced rate. This message could also mean that the switch or CPE is faulty. Recommended Action Change the profile on the port to one that has a lower rate or has a longer reach. There might be too many impairments on the connection between the switch and the CPE for the ports to sustain the profile rate. If you suspect the switch or CPE is faulty, contact Cisco Systems. MAT Messages This section contains the MAC address table error messages. Error Message MAT-1-BADFRAME: A bad packet is received on switch port [chars] Explanation A packet with either a switch error, a network error, or a wrong port number is received by the address learning process. Recommended Action If problems persist, copy the error message exactly as it appears on the console or in the system log. Enter the show tech-support command to gather data that might provide information to determine the nature of the error. If you cannot determine the nature of the error from the error message text or from the show tech-support output, contact your Cisco technical support representative, and provide the representative with the gathered information. Error Message MAT-1-NOMEM: Could not allocate memory for [chars] at line [dec] in [chars] Explanation System ran out of memory; internal software error. Recommended Action Copy the error message exactly as it appears on the console or in the system log. Enter the show tech-support command to gather data that might provide information to determine the nature of the error. If you cannot determine the nature of the error from the error message text or from the show tech-support output, contact your Cisco technical support representative, and provide the representative with the gathered information. A-22 Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide 78-6511-08