Compaq ML530R Service Guide - Page 137
Switches, Configuration Switch Settings
UPC - 720591250300
View all Compaq ML530R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
4-4 Compaq ProLiant ML530 Servers Maintenance and Service Guide Switches This section contains information concerning all switches located on Compaq ProLiant ML530 servers. The system board has one DIP switch. The system configuration switch location is shown in Figure 4-3. 1 2 3 4 5 6 Figure 4-3. System board configuration switch location NOTE: The processor speed of Compaq ProLiant ML530 servers is determined by the system ROM during Power-On Self-Test (POST). Therefore, it is not necessary to set any processor switch settings. Configuration Switch Settings The system board configuration switch settings are described in Table 4-3. Table 4-3 System Board Configuration Switch Settings Switch 1 Function Video 2 Lock configuration 3 Tower-to-rack conversion 4 Diskette boot feature 5 Power-on password 6 Maintenance On Embedded video disabled System configuration is locked and cannot be changed Rack-mount configuration Diskette enabled for booting, overriding System Configuration Utility Power-on password disabled NVRAM invalidated; configuration lost Off (Default) Embedded video enabled ROM controls embedded video System configuration can be changed Tower configuration Diskette boot controlled through System Configuration Utility Power-on password enabled NVRAM validated; configuration not lost