Compaq ML530R Service Guide - Page 69
Error Code, Audible Beeps, Probable Source of Problem, Recommended Action
UPC - 720591250300
View all Compaq ML530R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Diagnostics and Troubleshooting 3-9 Table 3-2 POST Error Messages continued Error Code Audible Beeps 174-Configuration/ None Slot Mismatch Device Not Found 175-Configuration/ None Slot Mismatch Device Found 177-Configuration None Not Complete 178-Processor None Configuration Invalid 180-Log Reinitialized None 201-Memory Error None 203-Memory Address Error 207-Invalid Memory Configuration - Check DIMM [SIMM] Installation 208-Invalid Memory Speed - Check DIMM [SIMM] Installation None None 1 long, 1 short 209-Memory Detection Failure. Check Memory Installation 211-Cache Switch Set Incorrectly 212-System Processor Failed/ Mapped Out 214-DC-DC Converter Failed 218-Cache Accelerators Not Installed. System Halted. 219-Tag Update Rules SRAM Failure. System Halted 1 long, 1 short None 1 short None None None Probable Source of Problem EISA or PCI board not found. Recommended Action Run the System Configuration Utility and correct. EISA or PCI board added, configuration not updated. Run the System Configuration Utility and correct. Incomplete system configuration Processor type or step does not match configuration memory. IML reinitializing due to log corruption. RAM failure RAM failure Memory module installed incorrectly. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Event message only, no action required. Run Diagnostics. Replace failed assembly as indicated. Run Diagnostics. Replace failed assembly as indicated. Verify placement of memory modules. The speed of the memory is not compatible with the server. Unable to size memory. Verify the speed of the memory modules installed, then check your server's user documentation, and replace the speed as indicated. Check DIMM installation and, if error persists, call your Compaq service provider. Switch not set properly during installation or upgrade. Processor in slot X failed. Verify switch settings. Run Diagnostics and replace failed processor. PowerSafe Module (DC-DC Converter) failed. Cache accelerators not installed or improperly installed. Run Diagnostics. Replace failed assembly as indicated. Check cache accelerator installation. Catastrophic chipset failure. Call Compaq service provider. continued