Compaq ML530R Service Guide - Page 70
the Keyboard Scan Code., Run the System Configuration
UPC - 720591250300
View all Compaq ML530R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
3-10 Compaq ProLiant ML530 Servers Maintenance and Service Guide Table 3-2 POST Error Messages continued Error Code Audible Beeps 219-Snoop Rules None SRAM Failure. System Halted. 220-Cache None Accelerator Slot X Initialization Failed. System Halted. 301-Keyboard Error None 301-Keyboard Error None or Test Fixture Installed ZZ-301-Keyboard None Error 303-Keyboard None Controller Error 304-Keyboard or None System Unit Error 40X-Parallel Port X Address Assignment Conflict 601-Diskette Controller Error 2 short None 605-Diskette Drive Type Error 1151-Com Port 1 Address Assignment Conflict 1152-Com Port 2, 3, or 4 Address Assignment Conflict 2 short 2 short 2 short Probable Source of Problem Catastrophic chipset failure. Cache accelerator in slot X improperly installed or bad. Keyboard failure Keyboard failure Keyboard failure. (ZZ represents the Keyboard Scan Code.) System board, keyboard, or mouse controller failure Keyboard, keyboard cable, or system board failure Both external and internal ports are assigned to parallel port X. Diskette controller circuitry failure Mismatch in drive type Both external and internal serial ports are assigned to COM1. Both external and internal serial ports are assigned to COM2, COM3, or COM4. Recommended Action Call Compaq service provider. Check cache accelerator installation and, if properly installed, replace. Turn off the computer, then reconnect the keyboard. Replace the keyboard. 1. A key is stuck. Try to free it. 2. Replace the keyboard. 1. Run Diagnostics. 2. Replace failed assembly as indicated. 1. Make sure the keyboard is attached. 2. Run Diagnostics. 3. Replace the part indicated. Run the System Configuration Utility and correct. 1. Make sure the diskette drive cables are attached. 2. Replace the diskette drive and/or cable. 3. Replace the system board. Run the System Configuration Utility to set diskette type correctly. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. continued