Compaq ML530R Service Guide - Page 24
RackMount Bezel, Access Panel
UPC - 720591250300
View all Compaq ML530R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Removal and Replacement Procedures 2-9 Rack-Mount Bezel WARNING: To reduce the risk of personal injury or damage to the equipment, do not use the rack-mount bezel handles or system board tray handle to move Compaq ProLiant ML530 servers. To remove the rack-mount bezel: 1. Perform the preparation procedures. See "Hot-Pluggable Device" earlier in this chapter. 2. Loosen the access panel screws or remove the access panel. See "Access Panel" later in this chapter. 3. Remove the four T-15 screws securing the rack-mount bezel to the chassis. 4. Pull the rack-mount bezel away from the chassis. 1 2 1 Figure 2-2. Removing the rack-mount bezel Reverse steps 1 through 4 to replace the rack-mount bezel.
Removal and Replacement Procedures
2-9
Rack-Mount Bezel
WARNING:
To reduce the risk of personal injury or damage to the equipment, do not use the
rack-mount bezel handles or system board tray handle to move Compaq ProLiant ML530
servers.
To remove the rack-mount bezel:
1.
Perform the preparation procedures. See
“
Hot-Pluggable Device
”
earlier in this chapter.
2.
Loosen the access panel screws or remove the access panel. See
“
Access Panel
”
later in
this chapter.
3.
Remove the four T-15
screws securing the rack-mount bezel to the chassis.
4.
Pull the rack-mount bezel
away from the chassis.
1
1
2
Figure 2-2.
Removing the rack-mount bezel
Reverse steps 1 through 4 to replace the rack-mount bezel.