Compaq ML530R Service Guide - Page 82

the System Configuration Utility, Run the System

Get Compaq ML530R - HP ProLiant - 128 MB RAM PDF manuals and user guides
UPC - 720591250300
View all Compaq ML530R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 82 highlights

3-22 Compaq ProLiant ML530 Servers Maintenance and Service Guide Table 3-2 POST Error Messages continued Error Code Audible Beeps 1793-Drive Array - None Array Accelerator Battery Depleted - Data Lost (Error message 1794 also displays.) 1794-Drive Array - None Array Accelerator Battery Charge Low. Array Accelerator is temporarily disabled. Array Accelerator will be re-enabled when battery reaches full charge. 1795-Drive Array - None Array Accelerator Configuration Error. Data does not correspond to this drive array. Array Accelerator is temporarily disabled. 1796-Drive Array - None Array Accelerator Not Responding. Array Accelerator is temporarily disabled. 1797-Drive Array - None Array Accelerator Read Error Occurred. Data in Array Accelerator has been lost. Array Accelerator is disabled. Probable Source of Problem While the system was in use, power was interrupted while data was in the array accelerator memory. The array accelerator batteries failed. Power was not restored within 8 to 10 days. Data in the array accelerator has been lost. This is a warning that the battery charge is below 75%. Posted-writes are disabled. Recommended Action Perform orderly system shutdowns to eliminate data remaining in the array accelerator. Replace the array accelerator board if batteries do not recharge within 36 power-on hours. While the system was in use, power was interrupted while data was in the array accelerator memory. The data stored in the array accelerator does not correspond to this drive array. Match the array accelerator to the correct drive array, or run the System Configuration Utility to clear the data in the array accelerator. Array accelerator is defective or has been removed. Hard parity error while reading data from posted-writes memory. 1. Check that the array accelerator is properly seated. 2. Run the System Configuration Utility to reconfigure the Compaq IDA-2 without the array accelerator. Enable array accelerator. continued

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
3-22
Compaq ProLiant ML530 Servers Maintenance and Service Guide
Table 3-2
POST Error Messages
continued
Error Code
Audible Beeps
Probable Source of Problem
Recommended Action
1793-Drive Array
–
Array Accelerator
Battery Depleted
–
Data Lost
(Error message 1794
also displays.)
None
While the system was in use,
power was interrupted while data
was in the array accelerator
memory. The array accelerator
batteries failed. Power was not
restored within 8 to 10 days.
Data in the array accelerator has
been lost.
Perform orderly system
shutdowns to eliminate data
remaining in the array
accelerator.
1794-Drive Array
–
Array Accelerator
Battery Charge Low.
Array Accelerator is
temporarily disabled.
Array Accelerator will
be re-enabled when
battery reaches full
charge.
None
This is a warning that the battery
charge is below 75%.
Posted-writes are disabled.
Replace the array accelerator
board if batteries do not
recharge within 36 power-on
hours.
1795-Drive Array
–
Array Accelerator
Configuration Error.
Data does not
correspond to this
drive array. Array
Accelerator is
temporarily disabled.
None
While the system was in use,
power was interrupted while data
was in the array accelerator
memory.
The data stored in the array
accelerator does not correspond
to this drive array.
Match the array accelerator to
the correct drive array, or run
the System Configuration Utility
to clear the data in the array
accelerator.
1796-Drive Array
–
Array Accelerator Not
Responding.
Array Accelerator is
temporarily disabled.
None
Array accelerator is defective or
has been removed.
1.
Check that the array
accelerator is properly
seated.
2.
Run the System
Configuration Utility to
reconfigure the Compaq
IDA-2 without the array
accelerator.
1797-Drive Array
–
Array Accelerator
Read Error Occurred.
Data in Array
Accelerator has been
lost. Array
Accelerator is
disabled.
None
Hard parity error while reading
data from posted-writes
memory.
Enable array accelerator.
continued