Compaq nx9010 Maintenance and Service Guide - Page 70
Removing the Heat Sink with Fan, CAUTION, Reassembly Notes, Removal and Replacement
View all Compaq nx9010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
3. Disconnect the 2 fan cables from the motherboard. 4. Remove the 4 retaining M2.0×5.0mm screws in the "1," "2," "3," "4" sequence stamped on the heat sink. 5. Lift up on the heat sink (with fan). Figure 2-27. Removing the Heat Sink (with Fan) HP Pavilion 5x00, HP Compaq nx9010 and nx9008, and Compaq Presario 2500 Models CAUTION: Do not spin the fan blades with your finger or you could damage the fan's bearings. Reassembly Notes • If the thermal pad is damaged, use a sharp knife or scraper to carefully remove it from the heat sink, and then attach a new thermal pad. • Install the heat sink screws in this order: 1. Install all 4 screws lightly. 2. Fully tighten the screws in the order stamped on the heat sink. 2-40 Removal and Replacement Service Manual