Compaq nx9010 Maintenance and Service Guide - Page 76
Removing the CPU Module, Reassembly Notes, CAUTION, thermal pad from the heat sink
View all Compaq nx9010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
3. Slide the front tip of the locking arm slightly to the right, and then swing it up and back. 4. Carefully lift the CPU module off of its socket on the motherboard. Reassembly Notes Figure 2-32. Removing the CPU Module HP Pavilion ze5x00, HP nx9010 and HPnx9008, and Compaq Presario 2500 Models CAUTION: Each time you install a new CPU module, you must also replace the heat sink's thermal pad to maintain optimum heat transfer. Use a sharp knife or scraper to carefully remove the old thermal pad from the heat sink, and then attach the new thermal pad. • The CPU module is keyed for installation, and can be inserted only one way. • Carefully insert the CPU module into the motherboard, and then swing the locking arm forward and down. Make sure the clip on the right side of the CPU module socket secures the locking arm. • Be sure to replace the thermal pad on the heat sink, as described in the Caution above. 2-46 Removal and Replacement Service Manual