D-Link DWC-2000-AP32-LIC User Manual - Page 247

Section 8 - Maintenance 2. Enable the trap as desired (refer to the table below). 3. Click Save. Field AP Failure Traps AP State Change Traps Client Failure Traps Client State Change Traps Peer Controller Traps RF Scan Traps Rogue AP Traps Description If you enable this field, the SNMP agent sends a trap if an AP fails to associate or authenticate with the controller If you enable this field, the SNMP agent sends a trap for one of the following reasons: • Managed AP Discovered • Managed AP Failed • Managed AP Unknown Protocol Discovered • Managed AP Load Balancing Utilization Exceeded If you enable this field, the SNMP agent sends a trap if a wireless client fails to associate or authenticate with an AP that is managed by the controller. If you enable this field, the SNMP agent sends a trap for one of the following reasons associated with the wireless client: • Client Association Detected • Client Disassociation Detected • Client Roam Detected If you enable this field, the SNMP agent sends a trap for one of the following reasons associated with a peer controller • Peer Controller Discovered • Peer Controller Failed • Peer Controller Unknown Protocol Discovered • Configuration command received from peer controller. (The controller does not need to be Cluster Controller for generating this trap.) If you enable this field, the SNMP agent sends a trap when the RF scan detects a new AP, wireless client, or ad‐hoc client. If you enable this field, the SNMP agent sends a trap when the controller discovers a rogue AP. The agent also sends a trap every Rogue Detected Trap Interval seconds if any rogue AP continues to be present in the network. D-Link DWC-2000 User Manual 247