Dell External OEMR 2970 User Guide - Page 123
Example Commands, omconfig rac dialoutusers
View all Dell External OEMR 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Example Commands The following example sets one name=value pair. Type: omconfig rac dialinusers username=jdoe The next example supplies values for all command parameters that you can use with the omconfig rac dialinusers command. Type: omconfig rac dialinusers username=jdoe index=0 password=steven70 callbacknumber=4441022 callbacktype=preset The following message appears: Command Successful. Please reset RAC card! omconfig rac dialoutusers Use the omconfig rac dialoutusers command to specify requirements for each user who is to have dial-out privileges. The administrator can specify values for a surname, password, IP address, and other properties for each dial-out user. Table 7-3 shows the valid parameters for the command. Table 7-3. omconfig rac dialoutusers name=value pair ipaddr= index= username= password= phonenumber= authtype=any | encrypted Description Sets the IP address, which must be specified in dotted-decimal notation. Sets the dial-out user index to populate with user name, password, and so on. The index specifies one of the 16 user "positions" on the RAC. If an index is not specified for an omconfig rac command, the entry is added to the next available position on the RAC. If an index is specified for an omconfig rac command and another entry exists for that position, the key field parameter is used to decide if the command should be executed. If the key field supplied by the user matches the key field of the entry on that specific position of the RAC, the RAC entry is edited. Otherwise, the command fails. Sets the user name for the point-to-point protocol (PPP) dial-out user. Sets the password for this PPP user. Sets the number where you can reach the PPP user. Sets the type of authentication required for this user. omconfig rac: Managing the Remote Access Controller 123