Dell External OEMR 2970 User Guide - Page 169

Complete Syntax action=blink controller=ID action=blink controller=id pdisk= where id is the controller ID. The variable specifies the physical disk. To obtain these values, enter omreport storage controller to display the controller IDs and then enter omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller. Example Syntax In this example, you want to blink physical disk 0 on connector 0 of controller 1. On a SAS controller, the physical disk resides in enclosure 2. Example for SCSI, SATA, and ATA Controllers: To blink the physical disk described in this example, enter: omconfig storage pdisk action=blink controller=1 pdisk=0:0 Example for SAS Controllers: To blink the physical disk described in this example, enter: omconfig storage pdisk action=blink controller=1 pdisk=0:2:0 omconfig Unblink Physical Disk You can unblink the light (light emitting diode or LED display) on one or more physical disks attached to a controller. Use the following omconfig command syntax to unblink one or more physical disks. Complete Syntax omconfig storage pdisk action=unblink controller=id pdisk= where id is the controller ID. The variable specifies the physical disk. To obtain these values, enter omreport storage controller to display the controller IDs and then enter omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller. Example Syntax In this example, you want to unblink physical disk 0 on connector 0 of controller 1. On a SAS controller, the physical disk resides in enclosure 2. Example for SCSI, SATA, and ATA Controllers: To unblink the physical disk described in this example, enter: omconfig storage pdisk action=unblink controller=1 pdisk=0:0 Using the Storage Management Service 169