Dell External OEMR 2970 User Guide - Page 168

Complete Syntax action=rename controller=id vdisk=id name= where id is the controller ID and virtual disk ID as reported by the omreport command and is the new name for the virtual disk. To obtain the values for controller ID and virtual disk ID, enter omreport storage controller to display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller. Example Syntax For example, to rename virtual disk 4 on controller 1 to vd4, enter: omconfig storage vdisk action=rename controller=1 vdisk=4 name=vd4 omconfig Physical Disk Commands The following sections provide the omconfig command syntax required to execute physical disk tasks. Table 8-23. omconfig Physical Disk Commands Required Command Levels (1, 2, 3) Optional name=value pairs omconfig storage pdisk action=blink controller=id pdisk= action=unblink controller=id pdisk= action=remove controller=id pdisk= action=initialize controller=id pdisk= action=offline controller=id pdisk= action=online controller=id pdisk= action=assignglobalhotspare controller=id pdisk= assign= action=rebuild controller=id pdisk= action=cancelrebuild controller=id pdisk= action=removedeadsegments controller=id pdisk= omconfig Blink Physical Disk You can blink the light (light emitting diode or LED display) on one or more physical disks attached to a controller. Use the following omconfig command syntax to blink one or more physical disks. 168 Using the Storage Management Service