Dell External OEMR 2970 User Guide - Page 149
omconfig Test Controller Alarm, omconfig Reset Controller Configuration
View all Dell External OEMR 2970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
omconfig Test Controller Alarm Use the following omconfig command syntax to test the functionality of the controller alarm. The alarm will sound for about two seconds. See the online help for more information about using this command. Complete Syntax omconfig storage controller action=testalarm controller=id where id is the controller ID as reported by the omreport storage controller command. Example Syntax For example, to test the alarm on controller 1, enter: omconfig storage controller action=testalarm controller=1 omconfig Reset Controller Configuration Use the following omconfig command syntax to reset the controller configuration. NOTICE: Resetting a configuration permanently destroys all data on all virtual disks attached to the controller. If the system or boot partition resides on these virtual disks, it will be destroyed. You may receive a warning message if this command will result in deleting the system or boot partition. However, this warning message is not generated in all circumstances. You should be certain that you are not deleting the system or boot partition or other vital data when using this command. Complete Syntax omconfig storage controller action=resetconfig controller=id where id is the controller ID as reported by the omreport storage controller command. In some circumstances, you may receive a warning message if this command will delete the system or boot partition. You can override this warning by using the force=yes parameter. In this case, the syntax is as follows: omconfig storage controller action=resetconfig controller=id force= yes Example Syntax For example, to reset the configuration on controller 1, enter: omconfig storage controller action=resetconfig controller=1 Using the Storage Management Service 149