Dell External OEMR 2970 User Guide - Page 146

Example Syntax The omconfig command syntax for rescanning all controllers on the system does not require that you specify a controller ID. To do a global rescan of all controllers, enter the following: omconfig storage globalinfo action=globalrescan NOTE: Global rescan is not supported on non-RAID SCSI and SAS controllers. You must reboot the system before Storage Management can see configuration changes on non-RAID SCSI controllers. omconfig Controller Commands The following sections provide the omconfig command syntax required to execute controller tasks. NOTICE: The omconfig storage controller action=resetconfig controller=id resets the controller configuration. Resetting the controller configuration permanently destroys all data on all virtual disks attached to the controller. If the system or boot partition resides on these virtual disks, it will be destroyed. Table 8-16. omconfig Controller Commands Required Command Levels (1, 2, 3) Optional name=value pairs omconfig storage controller action=rescan controller=id action=globalrescan action=enablealarm controller=id action=disablealarm controller=id action=quietalarm controller=id action=testalarm controller=id action=resetconfig controller=id [force=yes] action=createvdisk controller=id raid= size= pdisk= [stripesize=< 2kb| 4kb| 8kb| 16kb| 32kb| 64kb| 128kb>] [cachepolicy=] [readpolicy=] [writepolicy=] [name=] [spanlength=] action=setrebuildrate controller=id rate= action=setbgirate controller=id rate= action=setreconstructrate controller=id rate= 146 Using the Storage Management Service