Dell PowerEdge C6400 EMC Installation and Service Manual - Page 45
Installing a drive into the drive carrier
View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Figure 29. Removing the drive from the drive carrier Next steps 1. If applicable, install the drive into the drive carrier. Installing a drive into the drive carrier Prerequisites CAUTION: Mixing drive carriers from other generations of PowerEdge servers is not supported. NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs. 1. Follow the safety guidelines listed in Safety instructions. Steps 1. Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier. 2. Align the screw holes on the drive with the screws holes on the drive carrier. When aligned correctly, the back of the drive is flush with the back of the drive carrier. 3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with screws. Installing and removing enclosure components 45