Dell PowerEdge C6400 EMC Installation and Service Manual - Page 79

Installing the backplane

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 79 highlights

Figure 69. Removing the backplane Next steps 1. Install the backplane. Installing the backplane Prerequisites CAUTION: You must note the slot number of each drive and temporarily label them before removal so that you can replace them in the same slots. NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped. Follow the safety guidelines listed in Safety instructions. Steps 1. Orient the drive cage so that the drive bays are facing down. 2. Place the backplane on the drive cage, aligning the screw holes on the backplane with the holes on the drive cage. 3. Using the Phillips #2 screwdriver, replace the screws to secure the backplane to the drive cage. Installing and removing enclosure components 79

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Figure 69. Removing the backplane
Next steps
1.
Install the backplane
.
Installing the backplane
Prerequisites
CAUTION:
You must note the slot number of each drive and temporarily label them before removal so that you can
replace them in the same slots.
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
Follow the safety guidelines listed in
Safety instructions
.
Steps
1.
Orient the drive cage so that the drive bays are facing down.
2.
Place the backplane on the drive cage, aligning the screw holes on the backplane with the holes on the drive cage.
3.
Using the Phillips #2 screwdriver, replace the screws to secure the backplane to the drive cage.
Installing and removing enclosure components
79