Dell PowerEdge C6400 EMC Installation and Service Manual - Page 80

Removing the backplane expander board

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 80 highlights

Figure 70. Installing the backplane Next steps 1. Reconnect all the disconnected cables. 2. Install the drive cage into the enclosure. 3. Follow the procedure listed in After working inside your enclosure. Removing the backplane expander board Prerequisites NOTE: To prevent damage to the drives and backplane, you must remove the drives from the system before removing the backplane. NOTE: Observe the routing of the cable on the chassis as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped. NOTE: The backplane expander board is only available with 24 x 2.5-inch drives with NVMe configuration. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your enclosure. 3. Remove the drive cage. 4. Disconnect all the cables from the backplane expander board. 80 Installing and removing enclosure components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Figure 70. Installing the backplane
Next steps
1.
Reconnect all the disconnected cables.
2.
Install the drive cage into the enclosure
.
3.
Follow the procedure listed in
After working inside your enclosure
.
Removing the backplane expander board
Prerequisites
NOTE:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing
the backplane.
NOTE:
Observe the routing of the cable on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
NOTE:
The backplane expander board is only available with 24 x 2.5-inch drives with NVMe configuration.
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your enclosure
.
3.
Remove the drive cage
.
4.
Disconnect all the cables from the backplane expander board.
80
Installing and removing enclosure components