Dell PowerEdge C6400 EMC Installation and Service Manual - Page 86

Installing the thermal sensor board

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 86 highlights

Installing the thermal sensor board Prerequisites NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables properly on the chassis to prevent them from being pinched or crimped. 1. Follow the safety guidelines listed in Safety instructions. Steps 1. Install the thermal sensor board into the sensor board holder, and using the Phillips #1 screwdriver, secure it to the holder. 2. Connect the cable to the sensor board assembly. 3. Install the sensor board assembly into the drive cage. 4. Replace the screw that secures the sensor board assembly to the drive cage. Figure 78. Installing the sensor board assembly Next steps 1. Replace the drive cage into the chassis. 2. Connect all the cables to the backplane. 3. Connect the control panel cables to the midplane. 4. Install the drives. 5. Follow the procedure listed in After working inside your enclosure. 86 Installing and removing enclosure components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Installing the thermal sensor board
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these
cables properly on the chassis to prevent them from being pinched or crimped.
1.
Follow the safety guidelines listed in
Safety instructions
.
Steps
1.
Install the thermal sensor board into the sensor board holder, and using the Phillips #1 screwdriver, secure it to the holder.
2.
Connect the cable to the sensor board assembly.
3.
Install the sensor board assembly into the drive cage.
4.
Replace the screw that secures the sensor board assembly to the drive cage.
Figure 78. Installing the sensor board assembly
Next steps
1.
Replace the drive cage into the chassis
.
2.
Connect all the cables to the backplane.
3.
Connect the control panel cables to the midplane.
4.
Install the drives
.
5.
Follow the procedure listed in
After working inside your enclosure
.
86
Installing and removing enclosure components