Dell PowerEdge C6400 EMC Installation and Service Manual - Page 64

Midplane, Removing the right midplane

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 64 highlights

3. Follow the procedure listed in After working inside your enclosure. Midplane Removing the right midplane Prerequisites NOTE: Observe the routing of the cables on the chassis as you remove them from the system. Route these cables properly when you replace them to prevent the cables from being pinched or crimped. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in After working inside your enclosure. 3. Remove all the sleds from the enclosure. 4. Remove the cooling fan cage. 5. Disconnect all the connected cables. Steps 1. Using the Phillips #1 screwdriver, remove the screws that secure the midplane to the chassis. 2. Lift the midplane out of the chassis. 3. Using the Phillips #1 screwdriver, remove the screws that secure the power cables to the midplane. Figure 51. Removing the right midplane Next steps 1. Install the right midplane. 64 Installing and removing enclosure components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
3.
Follow the procedure listed in
After working inside your enclosure
.
Midplane
Removing the right midplane
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. Route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure listed in
After working inside your enclosure
.
3.
Remove all the sleds from the enclosure
.
4.
Remove the cooling fan cage
.
5.
Disconnect all the connected cables.
Steps
1.
Using the Phillips #1 screwdriver, remove the screws that secure the midplane to the chassis.
2.
Lift the midplane out of the chassis.
3.
Using the Phillips #1 screwdriver, remove the screws that secure the power cables to the midplane.
Figure 51. Removing the right midplane
Next steps
1.
Install the right midplane
.
64
Installing and removing enclosure components