Dell PowerEdge C6400 EMC Installation and Service Manual - Page 55

Installing the cooling fan cage

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

Figure 39. Removing the cooling fan cage Next steps 1. Install the cooling fan cage. Installing the cooling fan cage Prerequisites WARNING: Do not attempt to operate the system without the cooling fans. NOTE: Observe the routing of the cables when removing them from the system. Route these cables properly when you replace them to prevent the cables from being pinched or crimped. 1. Follow the safety guidelines listed in Safety instructions. Steps 1. Align the guide pins on the cooling fan cage with the guide holes on the chassis. 2. Install the fan cage onto the chassis, and push until it is firmly seated on the guide holes. 3. Connect the fan power cable to the connector on the chassis management board. To prevent the cable from being damaged, route this cable properly. Installing and removing enclosure components 55

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Figure 39. Removing the cooling fan cage
Next steps
1.
Install the cooling fan cage
.
Installing the cooling fan cage
Prerequisites
WARNING:
Do not attempt to operate the system without the cooling fans.
NOTE:
Observe the routing of the cables when removing them from the system. Route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1.
Follow the safety guidelines listed in
Safety instructions
.
Steps
1.
Align the guide pins on the cooling fan cage with the guide holes on the chassis.
2.
Install the fan cage onto the chassis, and push until it is firmly seated on the guide holes.
3.
Connect the fan power cable to the connector on the chassis management board.
To prevent the cable from being damaged, route this cable properly.
Installing and removing enclosure components
55