Dell PowerEdge C6400 EMC Installation and Service Manual - Page 61
Linking board, Removing the linking board
View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Figure 46. Installing the chassis management board Next steps 1. Reconnect all the disconnected cables. 2. Install the power interposer board. 3. Install the power supply units. 4. Follow the procedure listed in After working inside your enclosure. Linking board Removing the linking board Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your enclosure. 3. Remove all the sleds from the enclosure. 4. Remove the fan cage. Steps 1. Using the Phillips #1 screwdriver, remove the screw that secures the linking board to the enclosure. 2. Lift the linking board out of the enclosure. 3. Disconnect all the attached cables. Installing and removing enclosure components 61