Dell PowerEdge C6400 EMC Installation and Service Manual - Page 81

Installing the backplane expander board

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 81 highlights

Steps 1. Using the Phillips #2 screwdriver, remove the screws that secure the backplane expander board to the drive cage. 2. Lift the backplane expander board out of the enclosure. Figure 71. Removing the backplane expander board Next steps 1. Install the backplane expander board. Installing the backplane expander board Prerequisites NOTE: Observe the routing of the cable on the chassis as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped. NOTE: The backplane expander board is only available with 24 x 2.5-inch drives with NVMe configuration. 1. Follow the safety guidelines listed in Safety instructions. Steps 1. Install the backplane expander board into the enclosure, aligning the screw holes on the board with the holes on the drive cage. 2. Using the Phillips #2 screwdriver, secure the backplane expander board to the chassis. Installing and removing enclosure components 81

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Steps
1.
Using the Phillips #2 screwdriver, remove the screws that secure the backplane expander board to the drive cage.
2.
Lift the backplane expander board out of the enclosure.
Figure 71. Removing the backplane expander board
Next steps
1.
Install the backplane expander board
.
Installing the backplane expander board
Prerequisites
NOTE:
Observe the routing of the cable on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
NOTE:
The backplane expander board is only available with 24 x 2.5-inch drives with NVMe configuration.
1.
Follow the safety guidelines listed in
Safety instructions
.
Steps
1.
Install the backplane expander board into the enclosure, aligning the screw holes on the board with the holes on the drive cage.
2.
Using the Phillips #2 screwdriver, secure the backplane expander board to the chassis.
Installing and removing enclosure components
81