Dell PowerEdge C6400 EMC Installation and Service Manual - Page 51

Backplane cover, Removing the backplane cover

Get Dell PowerEdge C6400 PDF manuals and user guides View all Dell PowerEdge C6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Figure 34. Installing the system cover Next steps 1. Reconnect the peripherals, and connect the system to the electrical outlet. 2. Power on the system, and all attached peripherals. Backplane cover Removing the backplane cover Prerequisites NOTE: This procedure is not applicable for enclosures with the 3.5-inch hard drive configuration. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your enclosure. Steps 1. Using the Phillips #1 screwdriver, remove the screws that secure the backplane cover to the enclosure. 2. Slide the backplane cover toward the back of the enclosure and lift the cover away. Installing and removing enclosure components 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Figure 34. Installing the system cover
Next steps
1.
Reconnect the peripherals, and connect the system to the electrical outlet.
2.
Power on the system, and all attached peripherals.
Backplane cover
Removing the backplane cover
Prerequisites
NOTE:
This procedure is not applicable for enclosures with the 3.5-inch hard drive configuration.
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your enclosure
.
Steps
1.
Using the Phillips #1 screwdriver, remove the screws that secure the backplane cover to the enclosure.
2.
Slide the backplane cover toward the back of the enclosure and lift the cover away.
Installing and removing enclosure components
51