Dell PowerEdge MX840c EMC PowerEdge MX840c Installation and Service Manual - Page 59
Installing a drive into the drive carrier, Removing a drive from the drive carrier
View all Dell PowerEdge MX840c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Figure 29. Removing a drive from the drive carrier Next steps 1. Install a drive into the drive carrier. Installing a drive into the drive carrier Prerequisites 1. Follow the safety guidelines listed in the Safety instructions section. CAUTION: Mixing drive carriers from other generations of PowerEdge servers is not supported. NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs. Steps 1. Place the drive into the drive carrier with the connector end of the drive towards the back of the carrier. 2. Align the screw holes on the drive with the screws holes on the drive carrier. 3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with screws. Installing and removing sled components 59