Dell PowerEdge MX840c EMC PowerEdge MX840c Installation and Service Manual - Page 70
Installing the BBU module
![]() |
View all Dell PowerEdge MX840c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
5. Remove the drive cage. Steps 1. Press the tab on the side and push the BBU module from the rear end of the drive cage to release the BBU module. 2. Holding the BBU module by the edges, slide the BBU module out of the drive cage. Figure 45. Removing the BBU module Next steps 1. Remove the BBU from the BBU cage. 2. Install the BBU module. Installing the BBU module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions section. 2. Follow the procedure listed in the Before working inside your sled section. 3. Install the BBU into the BBU cage. 4. Install the drive cage. Steps 1. Route the cables on the BBU module through the front end of the sled. 2. Slide the BBU module until it firmly locks in place with the drive cage. 70 Installing and removing sled components
![](/manual_guide/products/dell-poweredge-mx7000-emc-poweredge-mx840c-installation-service-manual-cd200d6/70.png)