Dell PowerEdge R200 Hardware Owner's Manual (PDF) - Page 27
SATA Port 0/1/2 set as Auto
View all Dell PowerEdge R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Table 1-4. System Messages (continued) Message Causes Corrective Actions SATA Port 0/1/2 SATA Port 0/1/2 set as Auto, Run the System Setup hard disk not found no disk installed. program to correct the settings. See "Using the System Setup Program" on page 35. Sector not found Seek error Seek operation failed Faulty diskette or hard drive. See "Troubleshooting a USB Device" on page 102 or "Troubleshooting a Hard Drive" on page 111 for the appropriate drive installed in your system. Shutdown failure Shutdown test failure. Ensure that all memory modules are properly installed. See "Troubleshooting System Memory" on page 108. If the problem persists, see "Getting Help" on page 127. The amount of system memory has changed. Faulty memory module. Information only, if you have changed the memory configuration. See "Troubleshooting System Memory" on page 108. If the problem persists, see "Getting Help" on page 127. Faulty memory module. See "Troubleshooting System Memory" on page 108. If the problem persists, see "Getting Help" on page 127. Time-of-day clock Faulty battery; faulty stopped system board. See "Troubleshooting the System Battery" on page 106. If the problem persists, see "Getting Help" on page 127. About Your System 27