Dell PowerEdge R200 Hardware Owner's Manual (PDF) - Page 95
SATA_2 connector., Install the cooling shroud. See Installing the Cooling Shroud
View all Dell PowerEdge R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
13 Connect the control-panel interface cable to the FP_CONN1 connector on the system board. See Figure 6-2 for the location of the FP_CONN1 connector. 14 If applicable, connect the optical drive interface cable to the SATA_2 connector on the system card. See Figure 6-2 for the location of the SATA_2 connector. 15 Install the cooling shroud. See "Installing the Cooling Shroud" on page 57. 16 Close the system. See "Closing the System" on page 55. Installing System Components 95
Installing System Components
95
13
Connect the control-panel interface cable to the FP_CONN1 connector
on the system board. See Figure 6-2 for the location of the FP_CONN1
connector.
14
If applicable, connect the optical drive interface cable to the SATA_2
connector on the system card. See Figure 6-2 for the location of the
SATA_2 connector.
15
Install the cooling shroud. See "Installing the Cooling Shroud" on page 57.
16
Close the system. See "Closing the System" on page 55.