Dell PowerEdge R200 Hardware Owner's Manual (PDF) - Page 88
See Using the System Setup Program on Setup program.
View all Dell PowerEdge R200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
15 Rotate the release lever back down until it snaps into place, securing the processor cover. 16 Install the heat sink. a Using a clean lint-free cloth, remove the existing thermal grease from the heat sink. NOTE: Use the heat sink that you removed earlier in this procedure. b Apply thermal grease evenly to the top of the processor. c Place the heat sink onto the processor. See Figure 3-18. d Using a #2 Phillips screwdriver, tighten in a diagonal pattern the four captive screws that secure the heat sink to the system board. See Figure 3-18. 17 Install the cooling shroud. See "Installing the Cooling Shroud" on page 57. 18 Close the system. See "Closing the System" on page 55. As the system boots, it detects the presence of the new processor and automatically changes the system configuration information in the System Setup program. 19 Press to enter the System Setup program, and check that the processor information matches the new system configuration. See "Using the System Setup Program" on page 35. 20 Run the system diagnostics to verify that the new processor operates correctly. See "Running the System Diagnostics" on page 117 for information about running the diagnostics and troubleshooting processor problems. 88 Installing System Components