Dell PowerEdge R250 EMC Installation and Service Manual - Page 26
Installing the optical drive
![]() |
View all Dell PowerEdge R250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Figure 15. Removing the optical drive Next steps Replace the optical drive. Installing the optical drive Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped. Steps 1. Align and slide the optical drive into the optical drive slot on the system until it latches. 2. Connect the power cable and signal cable to the optical drive. 26 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r250-emc-installation-service-manual-5f691d2/26.png)
Figure 15. Removing the optical drive
Next steps
Replace the optical drive.
Installing the optical drive
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1.
Align and slide the optical drive into the optical drive slot on the system until it latches.
2.
Connect the power cable and signal cable to the optical drive.
26
Installing and removing system components